Visioneer XP100 Manuale Utente Scaricare il pdf

Visioneer XP100 Sheetfed Scanner Linux Drivers

Manual, API, and Development Notes

J.B. KOPENA

, R.A. PRIMERANO

Secure Wireless Agent Testbed Project

Department of Computer Science,

Department of Electrical and Computer Engineering

College of Engineering, Drexel University

http://swat.coe.drexel.edu/

1 Introduction

This document outlines code and programs developed for using a Visioneer

XP100 sheetfed scanner under Linux. The following section describes instal-

lation of the code and usage of included utility programs. This is followed in

Section 3 by notes on development of this code, including the settings and pro-

tocols which have been discovered or determined for this particular scanner.

2 User’s Manual

This section outlines installation and usage of the driver code.

2.1 Installation

The XP100 scanner provides only for USB access. Interaction with the scanner

in this software through the USB interface is accomplished via the LibUSB

library. LibUSB provides for user-space access to USB devices connected to

the host. It is available from the LibUSB project’s homepage at [2]. The library

must be installed, as root, from either a source distribution or binary package

before compiling the scanner software. Note that most common, up to date

Linux distributions include a version of LibUSB which may be sufﬁcient. This

software has been tested and is known to work with LibUSB version 0.1.8, the

latest stable version as of this writing.

The latest archive for the XP100 Linux driver code may be obtained from

the same source as this document. This software does not have to be installed

Contact author: [email protected]

1 2 3 4 5 6 7 8

6 Visioneer XP100 Drivers 6

Sommario

Pagina 1

Visioneer XP100 Sheetfed Scanner Linux DriversManual, API, and Development NotesJ.B. KOPENA1, R.A. PRIMERANOSecure Wireless Agent Testbed ProjectDepar

Pagina 2

2 Visioneer XP100 Driversas root, nor the scanner application run as root. In particular, it does not haveto be run setiuid root.After unpackaging the

Pagina 3

Visioneer XP100 Drivers 3◦ -d[0|1|2|3] — The color depth at which to conduct the scan.Defaults to 3. Values are as follows:Mode Parameter Bits per Pix

Pagina 4

4 Visioneer XP100 DriversP34 4150 0 0 0 0 0 0 0 0 15 0 150 0 0 0 15 7 0 0 0 0 0 00 0 0 0 0 0 0 15 7 0 0 015 0 15 0 0 0 0 0 0 0 0 0As all numbers in th

Pagina 5

Visioneer XP100 Drivers 5parameterization registers.Raw valid values were obtained by installing the scanner and supplieddrivers on a Windows computer

Pagina 6 - 6 Visioneer XP100 Drivers

6 Visioneer XP100 DriversRegister Label Value00 Image Buffer01 Image Data Available02 I/O Flags03 DataPort Mode04 DataPort Address—MSB05 DataPort Addr

Pagina 7

Visioneer XP100 Drivers 7• Soft reset. Writing the scanner conﬁguration to the LM9833’s registersrequires that the scanner be in soft reset mode. The

Pagina 8

8 Visioneer XP100 Driverssize and scan width). It may be conﬁgured to either stop scan-ning upon reaching the end of the paper or to and continue(send